How Do Cord Drawn Curtains Work

Place both cords inside track section then slide carrier 1 onto track making sure the knotted cord remains at the top. If the rod was properly installed to match the width of the curtain the carrier will be in the center of the rod.

Closing Your Curtains How To Keep Them Clean Shares An Easy Way To Add A Drapery Wand To Your Curtain Rod To Pull Cur Simple Curtains Diy Drapes Diy Curtains

A plastic clip is attached to the underside of the bracket with a loosening screw.

How do cord drawn curtains work. Pass the cord over the central bridge on Slave Master Slide F Twist cord to create a loop and hook over centre tab F Pass cord over the top of the bottom pulley in opposite End Pulley. Slide carrier 2 onto track section making sure this cord remains at the bottom. Push bottom cord between plastic slides of carrier 2.

Drapery Stacks A typical center-draw traverse rod pulley system operates with four pulleys and a draw cord that opens or closes the drapes -- two pulleys are at each corner. Pull the cord from the rod cutting it free from any tangles. Center Draw Traverse Rod Seen From the Back Positioning the Secondary Carrier.

Installing your own Windoware Extendable Curtain Rod has never been so simple with this Easy DIY step by step installation video. Pull on the draw cord to close the drape the primary carrier will traverse until the drapery or curtain panel on that side is fully extended. They slide freely pulled behind the master carrier from the center to the sides carrying the drapes along the rod.

Maneuver the new cord into the rods. Super Heavy Duty Traverse Curtain Rod 84-156 Inch White Center Draw 41 out of 5 stars 171. Then feed cord around and over the top pulley G Pass cord back through Ovelrap Master Slide.

This system is used with the majority of our curtain tracks. NICETOWN Rope Cord Curtains Tiebacks for Thick Curtains - Tie Pull Back Cord Weave Holdbacks for Indoor and Outdoor Use Silver White 30 inches Long Set of 2. Place the rod with the hardware facing up and feed the new cord under the top pulley on the left end of the rod.

Only 4 left in stock - order soon. The traverse system consists of a draw cord that runs in a loop through the track of the rod and around pulleys at the corners. Click to see full answer.

Crossing cords over will result in jamming when drawing curtains. Unscrew the brackets that hold the rod in place and take the rod down. This video is suitable for.

The track is a channel that accommodates the cord and the carriers. The groves along the top of the track are pushed up in to the plastic clip on one side and the metal notch on the other snapping the track in place.

Pin On Decorating Tips