How To Pull Cord Curtains Work

Install a double stationary pulley on the right end of the curtain rod. Shim the pulleys if necessary.

Pin On Scott Weaver Videos

Pull cord until the Overlap Master Slide is in the correct center positon.

How to pull cord curtains work. Cord from the Slave Master Slide. Unscrew the brackets that hold the rod in place and take the rod down. When you want to adjust the blinds lower them or pull them up you can do it with the cord.

The plastic lift cord condenser condenses multiple curtain lift cords into one cord. Pull the cord from the rod cutting it free from any tangles. Maneuver the new cord into the rods track and through the opening.

I have hunted everywhere. Use the hook or clip to pull the cording out the other side. Feed the opposite end of the cord between the two pulleys on the left and secure under the carrier on the right.

Move Slave Master Slide so that is sat next to the Overlap Master Slide. I have a curtain track that you pull the cord and only one side works. Push the cord over the top left pulley pull it through the upper carrier and tie a knot to secure it.

The groves along the top of the track are pushed up in to the plastic clip on one side and the metal notch on the other snapping the track in place. Twist cord to create a loop and hook over tab on Slave Master Slide Pass the cord over the top of the bottom pulley wheel in same End Pulley E Pass the cord over. Install a single stationary pulley on the left end of the curtain rod.

If you find how to fix it let me know please. Push the cording below the slides and the. This mechanism is when you can lower down and push up the blinds and theyll stay just how you like through a pulley system.

The cord goes from the master slide to one end of the traverse rod where it loops over a pulley and then comes back through holes in the adjustable slide to the other end of the traverse rod. I guess something has just come off a roller. The anchor point for the rod shown is a plastic tab located just below the cord.

Of course it goes without saying that working with traverse rods is much easier with the drapes removed. It comes braided continuous loop making it easier to adjust with minimum style. Run the free end of the cording between the two pulleys on the left side of the curtain rail.

Ensure that the top of the cord path through the pulley is level with the center of the eye screws on the wooden rings. Now place the loop over the anchor point on the carrier. Tie a simple half hitch around a knitting needle or long nail to pull the cord along the rod from one side to the other.

Pull the Loop. A plastic clip is attached to the underside of the bracket with a loosening screw. The pulleys are located on the left and right and look like two small wheels stacked diagonally.

Using a small screwdriver pull the exposed cord out to form a loop as seen below. Curtain Rod Center Adjustment - Pull Out the Loop Anchor the Loop. Keep your curtain cords from tangling and make the pull easier to use wi.

Push the master carriers to the ends leaving the loop then pull the cords from the down pulley watching the loop at the master glider and loop it over the lug or cleat as it becomes taught for tracks corded from both sides this wont be necessary. Place the rod with the hardware facing up and feed the new cord under the top pulley on the left end of the rod.

Pin On Home

Closing Your Curtains How To Keep Them Clean Shares An Easy Way To Add A Drapery Wand To Your Curtain Rod To Pull Cur Simple Curtains Diy Drapes Diy Curtains